Rockwood Overhead Stops and Holders

To Convert From Hold Open to Stop Function

1. Remove the plastic end cap #1 at the spring end of the channel.
2. With 3/16" hex key wrench, loosen the set screw in shock block.
3. Remove the shock block plate and the hold open spring from the channel.
4. Remove the hold opoen spring from shock block.
5. Replace the shock block and block plate into channel.
6. Replace the plastic end cap.
7. Install unit on door.
8. Adjust to desired opening and tighten set screw.

To Select Degree of Stop (Hold Open Models)

1. Engage door in hold open position.
2. Using a 3/16" hex key wrench, loosen set screw in the shock block.
3. Open door to desired degree of opening.
4. Tighten set screw.
5. Verify door opening position and re-adjust if needed.